Product Description
We Now Have These Brand New Team Grand Wagoneer Exclusive Hood Bumper Adjusting Screws In Stainless Steel And They Are Made Here In The U.S.A. With American Steel.
Our Brand New Set Now Includes Everything You Need Including The Plastic Grommets Needed To Install These Hood Bumper Screws Along With New Bumpers & A Stainless Pair Of Washers To Give It A Seamless Look If You Want.Which Only Takes Minutes To Install.
This Kit Will Take You About 10-15 Minutes At Best To Install.
If Your Bumpers Are Worn Out Or The Grommets Holding The Screws Just Don't Cut It Anymore This Kit Is What Your Jeep Needs.
All You Do Is Measure How Tall The Screws Are Without The Bumpers On Each Side To Ensure The Hood Closes The Same Way And Then Remove The Old Screws And Remove The Old Grommets If They Even Exist As Most We See Are Brittle And Cracked Or Stripped.
Then Pop The New Ones In And Screw Down To The Same Height They Were Before.
These Are A Direct Replacement With Upgraded 304 Stainless Steel Material For The Screws To Prevent Any Future Corrosion Or Rust.
We Include Our Team Grand Wagoneer Bumpers Whether You Need Them Or Not To Make Sure The Whole Kit Looks New And Lasts A Lifetime.
Jeep Had Discontinued These Screws Back In 2009 And Since Then Have Not Been Available.
Only 1-Kit Required Per Jeep.
Fits:
1984-1991 GRAND WAGONEER
1963-1983 FULL SIZE WAGONEER
1974-1983 FULL SIZE CHEROKEE, CHEROKEE CHIEF
1963-1988 J10, J20 PICK UP TRUCK
OUR KIT INCLUDES:
QTY--2 STAINLESS STEEL HOOD BUMPER ADJUSTING SCREWS REPLACING OE PART# J0960139
QTY--2 PAIR OF RUBBER HOOD SCREW BUMPERS REPLACING PART# J0958556
QTY--2 PLASTIC GROMMET NUTS REPLACING PART# J0958557
QTY--2 STAINLESS STEEL WASHERS W/NEOPRENE RUBBER IF YOU WANT THE GROMMET TO MATCH OTHER STAINLESS SCREWS IN ENGINE COMPARTMENT.
TEAM GRAND WAGONEER STAINLESS STEEL HOOD ADJUSTING SCREWS W/BUMPERS, GROMMETS PART# J0960139SSKIT
