Product Description
This Is A Direct Replacement OE Style AMC 20 Rear Axle Pinion Gear Crush Sleeve Or Spacer.
Anytime Your Remove Or Install A Ri8ng & Pinion Gear You Will Need To Replace This Crush Sleeve To Set The Pinion Gear Preload.
Even If You Have To Take The New Ring & Pinion Out To Recheck For Any Reason You Will Require Another Crush Sleeve.
If All Goes Well & Good Installing A Ring & Pinion You Will Only Need One Of These But If You Are A Beginner Installing A Ring & Pinion You May Want To Purchase A Few Of These Ahead Of Time To Get The Preload Adjustment Perfect To Where There Is No Whining Noise When Driving.
Once Again Only One Is Needed But In Case You May Not Be Sure On How Well You Can Do A Ring & Pinion, You May Want To Purchase An Extra One In Case So That If You Do Need Another One You Will Not Have To Wait An Extra Week To Get It Shipped With Your Jeep Not Driving.
Save A Little Extra Money If Purchasing More Than One At A Time.
APPLICATIONS:
Jeep SJ & J-Series (1980-1986) w/ AMC 20 Rear Axle.
- Jeep CJ-5 (1976-1983) w/ AMC 20 Rear Axle.
- Jeep CJ-7 (1976-1986) w/ AMC 20 Rear Axle.
- Jeep CJ-8 (1981-1986) w/ AMC 20 Rear Axle.
REPLACES OE PINION CRUSH SLEEVE OR SPACER PART# J3185971
TEAM GRAND WAGONEER AMC20 REAR AXLE PINION GEAR CRUSH SLEEVE PART# J3185971
